heat transfer printing film for skateboards

heat transfer printing film for skateboards

Specification:

1)Thickness: 12micron, 15micron, 19micron, 24micron

2)Width: normal is 640mm,1500mm

3)Inner Core of Paper: 1 inch,3 inches

4)Normal Length: 120meters, 1000meters, 3000meters

5)Material: PET

6)Stamping type: for partial transfer, whole transfer and special transfer.

7)Recommended stamping parameter:

Temperature: 100-140°c(12micron); 110-150°c (15micron);120-170°c (19micron); 120-200°c (24micron)

speed: 3~8 s.

8)Usage & Warning:

Appropriate stamping foil ought to be chosen according to different varieties of textile. Much attention must be paid to temperature, pressure and speed in course of stamping. You'd better use rolling ironing in large area to prevent air bubbles.

9)Package:

12mic x 640mm x 120meters/roll package:

Each roll with PE bag, 10rolls in one carton, carton size: 0.66m x 0.35m x 0.14m

24mic x 750mm x 120meters/roll package:

Each roll with PE bag, 10rolls in one carton, carton size: 0.77m x 0.38m x 0.18m

12mic x 1500mm x 3000meters/roll package:

Each roll with PE bag, with stand-board on both of the roll, load on carton, the carton size: 0.3m x 0.3m x 1.55m

producing department

Packing

entrucking